This is the battery compartment hatch assembly for various models in the mid 1970s & 1980s. This is the door only, the plastic interior spacer piece that attaches to the...
This is the battery compartment hatch assembly for various models in the mid 1970s & 1980s. Compatible era: Mid 70s Original vintage part Outer edge to edge (door): 16-3/4" Outer edge to...
This is the interior cover panel from a Dometic AC unit. It was painted and does show some signs of yellowing underneath. The plastic is in good condition. Original...
This is the interior cover panel from an AC unit.
Original vintage part
Compatible era: Specific to AC model/make
Measurements: 15-3/4 x 17-5/8
Location: Interior ceiling
This is the left hand trim piece from the wheel well on a 70s-80s trailer. Original vintage part Compatible era: Early 70s-80s Measurements: 6 inches Condition notes: Faded paint as shown Location:...
These are the mounting brackets that slide inside the square style curtain rail located in the front or back of various year trailers. Original vintage part Compatible era: Early...
This "Excella 500" badge is for trailers from the mid 70s through the 1980s. It is held in place with screws. Original vintage part Compatible era: Mid 70s+ Measurements: Approximately 12...
This is the trim bezel for a clock & thermostat found in the center of the endcap on some mid 70s trailers. Original vintage part Compatible era: Mid 70s Measurements:...
This is a clock from the center front endcap on a mid 70s trailer. It usually sits in tandem with a thermostat. It uses 2 AA batteries. Original vintage part...
This is latch secures the plexiglass rock guard so it doesn't move while driving. Original vintage part Refurb suggestions: clean aluminum, replace wing screw. Can be used on left or right...